OPTIONS - Explained

Below is an example OPTIONS line.
We will use this for the exercise which you can use to custom build you own or use the OPTIONS calculator

Options=TS1=2350;TS2=2350;DIAL=0;TIMER=10;VOICE=0;SINGLE=0;LANG=0;

TS1=2350,235;

Set Statics you want on Slot 1
Separate each Talk Group with a comma

TS2=2350,2351;

Set Statics you want on Slot 2
Separate each Talk Group with a comma

DIAL=2350;

0=None.

Set default Enhanced Talk Groups (Dial-a-TG) TG 9 Slot 2
Only One Talk Group can be entered in this section

You should not have the same Talk Group set as static on Slot 1 or Slot 2

TIMER=10;

Time a Talk Group is held active for.  Pressing your PTT on a Talk Group sets this timer running.
You select any number of minutes you like here. But the recommended time is 10 or 5 mins

If setting more than two static to a slot, you might wish to set Timer to  1 or 2 min

VOICE=0;

0=OFF  1=ON.

15 minute Voice Ident can be set ON or OFF on Time Slot 2.

Your radio will RX from the network    "This is <YOUR CALL-SIGN> FreeDMR"

SINGLE=0;

ON=0 OFF=1

Single Mode can be either ON or OFF. Network default is: OFF

LANG=0;

Set the Language the SYSTEM VOICE comes back to you as.  0=Servers Default

Use the list below to select the language you wish to use. Then use the VOICE CODE in the next column

Each section is separated with a Semicolon
Does not matter what order the above codes are in

More information can be found on the FreeDMR website